8 signs your electrical panel needs an upgrade
Your electrical panel is the heart of your home's electrical system. Most of the time you never think about it. But many Orange County homes still run on panels installed when the house was built in the 1960s, '70s or '80s, long before EVs, induction ranges, heat pumps and home offices. Here are eight signs yours deserves a closer look.
1. Breakers trip often
An occasional trip is the breaker doing its job. Frequent trips, especially when two appliances run at once, mean a circuit is overloaded, a breaker is worn, or there's a fault. Resetting it over and over isn't a fix.
2. Heat, buzzing or a burning smell
A panel or breaker that's warm to the touch, buzzes or smells like burning plastic needs attention right away. Turn off the affected breaker if it's safe and call a licensed electrician. If you see smoke or fire, call 911.
3. Flickering or dimming lights
Lights that dim when the AC, microwave or dryer starts can point to an overloaded panel or loose connections, both of which can generate heat.
4. No room for new circuits
If there are no open spaces, or the panel is packed with "tandem" breakers squeezed in to make room, you've outgrown it. You'll feel it the moment you plan a remodel or an EV charger.
5. You're adding a big new load
An EV charger, heat pump, induction range, hot tub, ADU or all-electric remodel can push an older 100- or 125-amp service past its limit. A load calculation tells you for sure. Sometimes a load-management device avoids an upgrade, and sometimes an upgrade is the smart long-term move.
6. It's a brand inspectors flag
Panels made by Federal Pacific Electric (Stab-Lok breakers) and Zinsco are widely flagged by home inspectors and some insurers because of concerns that breakers may not trip when they should. If you see either name on your panel label, have it evaluated. Replacement is the usual recommendation.
7. Rust or corrosion
Rust on the panel or breakers, common near the coast and in panels mounted on exterior walls, can lead to poor connections and failures. Corrosion is a reason to replace, not paint over.
8. Your home inspector, insurer or solar installer says so
Inspection reports, insurance companies and solar installers all look closely at panels. If any of them flag yours, take it seriously and get a licensed electrician's opinion.
Upgrade, replace or neither?
- Panel replacement: a new panel at the same service size, with modern breakers and more spaces
- Service upgrade: increasing your home's capacity (for example, 100 to 200 amps), which involves the utility
- Neither: sometimes a repair, a load-management device or a subpanel is all you need. An honest electrician will tell you.
What to expect in Irvine and Orange County
Panel work needs a permit. The City of Irvine offers fast online permitting for licensed contractors on many common electrical jobs, including panel upgrades. If your service size is changing, your electrician coordinates the disconnect and reconnect with Southern California Edison (or SDG&E in parts of south Orange County). The utility's schedule usually sets the timeline. Most panel replacements are completed in a day, with the power off for part of it.
Get a straight answer about your panel
Text a photo of your panel (door open, label visible) to (949) 424-2525 for a quick first opinion, or request an estimate online. Royal Power Electric serves Irvine and all of Orange County.
Royal Power Electric · Licensed C-10 Electrical Contractor · CSLB Lic. #1161594